When you replace the boards use a homemade reveal set jig to match the reveal of the existing siding.
Replace overlapped siding at lower pieces.
Now the process is fairly simple.
Wooden lap siding lasts for many years but occasionally a piece sustains damage.
Subscribe to this old house.
Wood rot woodpecker beaks and hailstorm damage are common reasons.
You can use a tape measure to mark the reveal of each piece of replacement siding or make a spacer gauge from two blocks of wood screwed together.
Vinyl siding is installed from the bottom up so you must loosen it in the opposite direction.
Ask this old house general contractor tom silva helps a homeowner repair sections of his vinyl siding that have holes.
To install the replacement siding start at the bottom and work your way up.
Wedge the board away from the house by driving wedges up under the damaged board to pull it out from the sheathing below.
How to change a piece of broken wood siding.
Fiber cement siding is resistant to this type of decay and is available in the same dimensions and patterns as the hardboard products so you don t have to replace all the siding on the house just the pieces that are damaged.
Now we replaced the siding with a different type of siding called fiber cement.
To remove replace an entire wall of siding.
Reconnect all of the interlocking pieces using the siding tool to help you.
Once the snap seal releases use gloved fingers to loosen the siding to a distance of 3 feet from the corner.
J piece that locks into place with the lip on the lower piece.
When it s time to put the siding back on the wall just reverse the process.
Replace siding by working from the bottom up you might need a helper here.
Slide and snap the pieces of siding onto the courses below and replace the nails you removed.
You may want to drive the nails in new locations to ensure that they have good purchase.
Slide the vinyl siding removal tool just under the bottom lip of the uppermost piece of vinyl siding and pry gently upwards.
Attach the siding with 10d galvanized box nails driven into the overlap at least 1 2 in.
Above the bottom edge.
Repeat steps 3 5 for any additional courses of siding that you need to remove.
The courses should overlap by at least 1 in.
